Found very low voltage on my Trans Brake Switch up
#1
Member
CRAFTSMAN
Thread Starter
Join Date: Oct 2007
Posts: 53
Found very low voltage on my Trans Brake Switch up
I was wiring up my practice tree to my Biondo TB switch & it wouldnt work on the tree, but on any other switch I tested it worked.
I then took a voltage meter when it was hot normal 12 volts when open it was reading between .09 & .06 volts
I disconected the msd 2 step to see if any difference & still showed the same small voltage.
is this switch bad?
I then took a voltage meter when it was hot normal 12 volts when open it was reading between .09 & .06 volts
I disconected the msd 2 step to see if any difference & still showed the same small voltage.
is this switch bad?