Results 1 to 3 of 3

Thread: Have I been Had?

  1. #1
    Senior Member EXPERT BUILDER
    Join Date
    Mar 2003
    Posts
    288

    Have I been Had?

    I bought a BBC 502 Block from a guy in N C advertised as a Fresh from the machine shop & ready to assemble..(Ad 2217756)Fact of the matter is its not a 502 which has a bore size of 4.47 this bore is 4.55...Needless to say a 502 Piston rolls around in the hole! I asked him several times About it being a std bore because I had just purchased an almost new 502 Rotating assy.He assured me it was A std 502 fresh from the machineshop & ready to assemble..I gave him $1000 for it & split shipping(another $100).I have Tryed contacting him several times & left him messages & an Email but so far no response..I didnt have any problem getting him before the deal was closed?? Im hopeing he responds & makes this deal good,the block is junk to me.. The ad says it all 502...

  2. #2
    Moderator RACING JUNKIE Harbone's Avatar
    Join Date
    Aug 2007
    Posts
    3,944
    Blog Entries
    1
    I think you have been had in a bad way. I sent him a message, lets see if he replies but I bet he dont... :evil:
    Chris

    As close to "Normal" as I can get...

  3. #3
    . was going to suggest sleeves if you got stuck with the block . would have to check with BBC engine builders to see if block can handle another 3/32" bore. That will give a clean stock bore


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy