HP EST

Old 06-14-2011, 07:09 PM
  #1  
ejm
Senior Member
SENIOR BUILDER
Thread Starter
 
Join Date: Nov 2007
Location: indiana
Posts: 123
Default HP EST

ok my buddy has a stock 454 (crank, rods, and a little dish piston) with oval port heads with 2.25 int and 1.88 ex valves, bowls blended, and cleaned up a bit, performer rpm intake(not a air gap) and a 850 holley a edelbrock hyd flat tap cam with.560/.573 lift and 240/246 duration (p/n 7162) Any idea for him or me???? thanks guys!!!
ejm is offline  
Old 06-15-2011, 01:17 AM
  #2  
blowninjected540
Senior Member
EXPERT BUILDER
 
Join Date: Mar 2007
Location: Michigan
Posts: 379
Default

Too much Carb for that set-up.
blowninjected540 is offline  
Old 06-15-2011, 03:26 AM
  #3  
curtisreed
Senior Member
RACING JUNKIE
 
curtisreed's Avatar
 
Join Date: Feb 2004
Location: KIEFER, OK.
Posts: 1,312
Default

350-380ish hp and 400-420ish torque.

Curtis
curtisreed is offline  
Old 06-15-2011, 08:52 AM
  #4  
maxpower671
Senior Member
SENIOR BUILDER
 
Join Date: Dec 2005
Posts: 117
Default Headers?

Originally Posted by doorracer
350-380ish hp and 400-420ish torque.

Curtis
agree with Curtis' estimates!

you didn't mention the exhaust or headers that are going to be used? good, free flowing exhaust can help a bunch, the tubes wouldn't have to be huge to offer some potential..
maxpower671 is offline  
Old 06-15-2011, 02:09 PM
  #5  
ejm
Senior Member
SENIOR BUILDER
Thread Starter
 
Join Date: Nov 2007
Location: indiana
Posts: 123
Default

yes it will be open headers
ejm is offline  
Old 06-15-2011, 02:24 PM
  #6  
bixblk
Senior Member
DYNO OPERATOR
 
bixblk's Avatar
 
Join Date: Dec 2004
Location: Chicagoland area
Posts: 472
Default HP ?? guess

I had Joe Ryne do a rebuild very similar to this, awhile ago Mine had approx 10.25 to 1 compression yours might be a little bit
lower but probably close 9 to 1 depending on the dish and CC size of the chamber. (total combustion chamber volume)
anyway with a 750 holley DP it made 402 HP on an engine dyno and similar torque numbers. So it should be in that range probably 375 ish HP.
Mine was a street pump gas motor Sounded great and had good power.
bixblk is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -