Dont forget to take the camshaft to a machine shop or someone with a lathe and have the rear journal grooved or you will not get any oil to the top of the motor.
Dont forget to take the camshaft to a machine shop or someone with a lathe and have the rear journal grooved or you will not get any oil to the top of the motor.
If you matchup the cam with the cam bearings, you will be OK. The stock design cam had a groove in it. Stroked470 is correct - one of the two must have an oil passage.
Dont forget to take the camshaft to a machine shop or someone with a lathe and have the rear journal grooved or you will not get any oil to the top of the motor.
Thanks- I had the machine shop take care of that, when they did the block and rods.