carb spacer
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Feb 2010
Posts: 4
carb spacer
I am looking for a carb spacer to run on my 360cid crate motor. Just install an Edelbrock air gap 7576 with a 750 Holley. May have to go to a ½” for hood clearance, is 4 hole, 2 hole or wide open the best.
Mike
Mike
#3
Senior Member
RACING JUNKIE
Join Date: Nov 2008
Location: Niagara Falls, NY
Posts: 965
Originally Posted by mopar1968
I run a 4 hole spacer on my small block into a indy intake :!: :!:
Mark
Mark
#4
Senior Member
MASTER BUILDER
Join Date: Apr 2003
Location: Brookings South Dakota
Posts: 244
Every engine is different. Some like open spacers, some ported spacers.
Typically we see the 4 hole ported spacers work the best for most applications.
Hamburger makes a nice 1 inch ported spacer.
Typically we see the 4 hole ported spacers work the best for most applications.
Hamburger makes a nice 1 inch ported spacer.
#6
Junior Member
SHOW GUEST
Thread Starter
Join Date: Feb 2010
Posts: 4
carb spacer
Originally Posted by mopar1968
Mine is a ported 4 hole spacer. The bottom side of the holes are larger than the top of the holes.Engine was dynoed with spacer :!:
Mark
Mark
Mike
#7
Here it is if you will look the hole's are tapered, It work's like a champ on my car :!: :!: The guy's that dynoed my engine worked to get me the best from the engine and found this plate work's great :!: :!:
http://www.jegs.com/i/Barry-Grant/13...oductId=743575
Mark
http://www.jegs.com/i/Barry-Grant/13...oductId=743575
Mark