Results 1 to 4 of 4

Thread: New Dart SHP Pro blocks

  1. #1
    Senior Member EXPERT BUILDER
    Join Date
    Nov 2003
    Location
    NORTHEAST
    Posts
    290

    New Dart SHP Pro blocks

    This really looks like a nice peice for the money

    This is the link
    http://www.dartheads.com/products/en...ro-blocks.html
    WWW.CNCBLOCKSNE.COM
    IS A DIVISION OF
    HINKSON AUTOMOTIVE
    RESEARCH & DEVELOPMENT

    CARL HINKSON 207-892-7215
    EMAIL [email protected]

  2. #2
    Senior Member EXPERT BUILDER
    Join Date
    Nov 2003
    Location
    NORTHEAST
    Posts
    290
    New P/N for these blocks.

    31161112 is the 4.000 bore block

    31161212 is the 4.125 bore block

    And their will be no one peice seal blocks availiable because they have no rear main billet cap for one peice seal crank.
    WWW.CNCBLOCKSNE.COM
    IS A DIVISION OF
    HINKSON AUTOMOTIVE
    RESEARCH & DEVELOPMENT

    CARL HINKSON 207-892-7215
    EMAIL [email protected]

  3. #3
    Senior Member EXPERT BUILDER
    Join Date
    Nov 2003
    Location
    NORTHEAST
    Posts
    290
    Dart just sent me a pic of the caps and bottom end view of the Pro SHP block if it fits your build contact you local Dart dealer!!!

    WWW.CNCBLOCKSNE.COM
    IS A DIVISION OF
    HINKSON AUTOMOTIVE
    RESEARCH & DEVELOPMENT

    CARL HINKSON 207-892-7215
    EMAIL [email protected]

  4. #4
    Senior Member EXPERT BUILDER
    Join Date
    Nov 2003
    Location
    NORTHEAST
    Posts
    290
    Got my Dart order in and had a chance to look over the Pro Block and so far have been pleased with what I saw and the mains were right in the middle, cam tunnel was right at 2.120 and the lifter bores were on the low side and depending whose lifters you are running they may have to be sized. To those who have asked about the studs on the outter splayed holes they are indeed 7/16 studs. Sonic test was very good!!

    NOTE we have been seeing a lot of under size roller lifters lately and anyone who is building an engine should measure all the lifters and size the lifter bores accordingly.

    Any one needing a specific picture of this block let me know!!
    WWW.CNCBLOCKSNE.COM
    IS A DIVISION OF
    HINKSON AUTOMOTIVE
    RESEARCH & DEVELOPMENT

    CARL HINKSON 207-892-7215
    EMAIL [email protected]


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy