Results 1 to 5 of 5

Thread: Hose Sleeves

  1. #1
    Senior Member MASTER BUILDER
    Join Date
    Aug 2007
    Location
    Iowa - USA
    Posts
    218

    Hose Sleeves

    Is there a good way to cut these stainless hose sleeves to fit hoses I want tp cover? Hack Saw is not the best.

  2. #2
    Senior Member RACING JUNKIE fla1976's Avatar
    Join Date
    Aug 2007
    Posts
    1,530
    Wrap the point where you want to cut with vinyl tape and cut it with a dremel tool.

  3. #3
    Senior Member RACING JUNKIE TheYellaBrick's Avatar
    Join Date
    Mar 2008
    Location
    Emmett, Idaho
    Posts
    7,334
    I wrap mine with duct tape and cut with a cutoff saw. If you use a cutoff wheel on a die grinder or a cutoff saw, go SLOW so you don't catch the braid and unravel it all over. Just eeeeeease through it.
    TRUTH is HATE
    to those who
    HATE TRUTH

    God Bless our folks in uniform
    "We the People, have your backs"
    http://www.racingjunk.com/profile/279898

  4. #4
    Senior Member RACING JUNKIE
    Join Date
    Mar 2006
    Location
    EUGENE,OR.
    Posts
    3,408
    Amen on both of those comments... make sure you wrap it tight.
    "I would walk through hell on Sunday before I fear the enemy"

  5. #5
    Senior Member DYNO OPERATOR
    Join Date
    Jan 2003
    Location
    Douglasville Ga
    Posts
    474
    Same here, I just wrap the part I need to cut with tape and cut it with a cut off wheel.

    Chris


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy