Circle track dirt car problem

Thread Tools
 
Old 07-12-2010, 05:13 PM
  #1  
dgordner
Member
JUNIOR BUILDER
Thread Starter
 
Join Date: Sep 2003
Location: Watsontown Pa.
Posts: 73
Default Circle track dirt car problem

I have a 355 with a holley 4412. When I get in the throttle coming off the turns, the engine bogs slightly and then comes back. This is all the way down the straights. Fine in the corners because of feathering. I have changed everything electrical in the car including complete wiring of the entire car. There is not an electrical component that I haven't changed. So now i am leaning on fuel delivery. I tried a Rochester carb and had the same problem. I have a racing fuel pump (can't tell ya the name right now). Any ideas where to go from here???
dgordner is offline  
Old 07-12-2010, 11:59 PM
  #2  
Tod74
Senior Member
RACING JUNKIE
 
Join Date: Sep 2007
Posts: 4,137
Default

Is your fuel pump good or is 100 years old? Also the fact that it does it with both carbs makes ya think it isn't geting enough fuel to the carb for some reason. Restricted fuel line faulty pump etc. I assume the float level is correct.

If you are allowed maybe put a fuel pressure gauge with an isolator , so you can watch the fuel pressure while you are running it.That would tell you if it was the carb or the fuel system.
Tod74 is offline  
Old 07-13-2010, 12:08 AM
  #3  
suicidebomb
Senior Member
RACING JUNKIE
 
Join Date: Jul 2007
Location: Independence, Missouri
Posts: 1,181
Default

I've always heard that 9/10ths of fuel problems, are in the ignition.
suicidebomb is offline  
Old 07-13-2010, 05:53 AM
  #4  
TheYellaBrick
Senior Member
RACING JUNKIE
 
TheYellaBrick's Avatar
 
Join Date: Mar 2008
Location: Emmett, Idaho
Posts: 7,334
Default


How old is the fuel cell foam ? Could be chunks of deteriorated cell foam blocking the inlet .
TheYellaBrick is offline  
Old 07-13-2010, 04:50 PM
  #5  
dgordner
Member
JUNIOR BUILDER
Thread Starter
 
Join Date: Sep 2003
Location: Watsontown Pa.
Posts: 73
Default

Well, you guys are all on the same thought pattern I am in regards to fuel pressure. Fuel pump is quite old. I didn't quite understand the post that said "most fuel problems is the ignition!!!!". The foam is as old as the fuel cell itself which is as old as the car and that is at least 10-12 years or more. I am going to start unhooking lines tomorrow and watch for flow. I also wonder about the fuel cap and the bleed valve. I will let ya know if I find it. Bad thing is, I never know until I get to the track and I loose money every time because of it.
dgordner is offline  
Old 07-13-2010, 05:08 PM
  #6  
fla1976
Senior Member
RACING JUNKIE
 
fla1976's Avatar
 
Join Date: Aug 2007
Posts: 1,523
Default

Fuel cell foam should be replaced every couple years according to the website below.

http://www.atlinc.com/faqs_racing.html
fla1976 is offline  
Old 07-14-2010, 05:21 AM
  #7  
suicidebomb
Senior Member
RACING JUNKIE
 
Join Date: Jul 2007
Location: Independence, Missouri
Posts: 1,181
Default

It was a joke, and a lousy joke at that, and I apologize.
suicidebomb is offline  
Old 07-14-2010, 07:00 AM
  #8  
TheYellaBrick
Senior Member
RACING JUNKIE
 
TheYellaBrick's Avatar
 
Join Date: Mar 2008
Location: Emmett, Idaho
Posts: 7,334
Default

That old of foam will require replacement !! You'll need to purge the COMPLETE fuel system. Remove the cell foam, the cell and clean, and blow out all your lines, filter/s, pickup screen, etc.
Even IF that does not fix the original issue, IT NEEDS TO BE DONE.
TheYellaBrick is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -