Results 1 to 1 of 1

Thread: SBC 350 distributor sits at angle w/single plane manifold

  1. #1

    SBC 350 distributor sits at angle w/single plane manifold

    Hi all, I recently purchased a `72 350 060 over sbc with a hurricane type single plane intake on it. Had no disributor in it when I bought it and has never been fired.(total rebuild) I finally got a distributor for it and dropped it in and the distributor sits at an angle?? The seat on the intake is flat(horizontal). Is this a special intake, maybe for a later model sbc? or is this the way distributor is suppose to sit in the motor.....I`m baffled?? Seems to me that the distributor hole is not in line with the hole in the block I`ve seen manifolds that actually have an angled seat for the distributor. Is this what I need?? Any help would be greatly appreciated.

  2. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy