2001 silverdo 5.3
04-20-2010, 09:06 AM
Senior Member
RACING JUNKIE
Thread Starter
Join Date: Apr 2010
Location: White Bluff TN
Posts: 630
2001 silverdo 5.3
2001 silverdo 5.3 Just replaced both head gaskets due to leak. Now is really hard to start.engine Motor spins over fine it acts like a fuel related problem. New filter did not help and now the service engine light is on. There is a problem with the port for the scan tool it will not connect to the computer. I am out of ideas any suggestions?
04-20-2010, 10:37 AM
Senior Member
DYNO OPERATOR
Join Date: Aug 2005
Location: Rifle Colorado
Posts: 585
Check the cig lighter fuse. If it's blown, scanner won't communicate with the ecm. Will it finally start? Have you checked the fuel pressure?
Johnny
04-20-2010, 11:34 AM
Senior Member
RACING JUNKIE
Thread Starter
Join Date: Apr 2010
Location: White Bluff TN
Posts: 630
I will check the fuse tonite. I have not checked the fuel pressure yet but that will my next step.
Thanks, for the help
04-20-2010, 11:36 AM
Senior Member
RACING JUNKIE
Thread Starter
Join Date: Apr 2010
Location: White Bluff TN
Posts: 630
Yes it will start it just take a lot of cranking
04-21-2010, 04:59 AM
Senior Member
RACING JUNKIE
Thread Starter
Join Date: Apr 2010
Location: White Bluff TN
Posts: 630
The lighter fuse was blown and the scanner showed a code for the cam shaft position sensor. I fixed the problem last night and it cranks and runs great thanks for the advice.
04-21-2010, 05:09 AM
Senior Member
DYNO OPERATOR
Join Date: Aug 2005
Location: Rifle Colorado
Posts: 585
No worries, glad I could help!
Later,
Johnny
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off