chassis cert?
#2
Senior Member
DYNO OPERATOR
Join Date: Aug 2007
Location: Lost Creek, WV
Posts: 533
Typically it involves tubing placement, tubing diameter, and tubing thickness. As far as leeway "NONE" either it's right or it's wrong and a chassis inspecter will not be bashful about telling you. Now going through tech is a little different, sometimes if something is wrong (depending on whats wrong) they will allow you to race but get it resolved before racing again. The chassis certs. are good for 3 years.
TS1955
TS1955
#3
Junior Member
SHOW GUEST
Thread Starter
Join Date: Dec 2008
Posts: 6
cool thank u sir, had another qestion i been welding for some time now i had a few welds get contaminated "wind blew a way my sheildin gas'' i ground it down and repared it. lol looks like $hit. wondering how they grade welds? thank you for your time.
#5
Senior Member
DYNO OPERATOR
Join Date: Jan 2003
Location: Douglasville Ga
Posts: 474
Hey guys, don't want to hijack the thread but I my Opel has a 8.50 IHRA cert on it right now and was told all I needed to make it a 7.50 cert was the two bars behind the seat that goes down to the floor. Does anyone know what size of piping this should be. I am using mild steel and did not know if it had to 1" 5/8 or not. Thanks in advance for the help and or advice.
Chris
Chris
#9
Senior Member
DYNO OPERATOR
Join Date: Jan 2003
Location: Douglasville Ga
Posts: 474
Originally Posted by rob41willys
Mild steel tubing has to be 1 5/8" .118 wall thickness if it is the bars I'm thinking your taking about.