Wheel spacers???
#1
Senior Member
SENIOR BUILDER
Thread Starter
Join Date: Sep 2009
Location: Newburgh, IN
Posts: 106
Wheel spacers???
I'm new to this kind of thing. But my question should be a good one. I have a high performance Mustang (nowhere near stock) and was wondering if wheel spacers on the rear wheels would hurt anything. I need to push these wheels out an inch or so. But I'm afraid with as much torque as I put down it would rip em off. Any input would be appreciated.
#2
As long as you have adequate studs (length and strength) you will not have a problem,
Jegs billet wheel spacers, 5 lug 4.25/4.50/4.75 pattern
555-65053 3/4" thick = $68 pair
555-65054 1" thick = $73 pair
Dave
Jegs billet wheel spacers, 5 lug 4.25/4.50/4.75 pattern
555-65053 3/4" thick = $68 pair
555-65054 1" thick = $73 pair
Dave
#3
Senior Member
SENIOR BUILDER
Thread Starter
Join Date: Sep 2009
Location: Newburgh, IN
Posts: 106
Originally Posted by oldandtired
As long as you have adequate studs (length and strength) you will not have a problem
#4
What you have to be careful of is exceeding the clamping force of your wheel studs. My roadster had been run for years before I got it with 1" wheel spacers and 1/2" studs. Light car and only running 6.40s-6.60s in the 1/8th.
I didn't feel comfortable with that setup so I got new wheels that didn't need the spacer. The problem to me is figuring out how much clamping force you have to have with the weight of your car, size of your tire and torque on the rearend, relating to the spacer and wheel stud involved.
Curtis
I didn't feel comfortable with that setup so I got new wheels that didn't need the spacer. The problem to me is figuring out how much clamping force you have to have with the weight of your car, size of your tire and torque on the rearend, relating to the spacer and wheel stud involved.
Curtis
#5
Originally Posted by doorracer
What you have to be careful of is exceeding the clamping force of your wheel studs. My roadster had been run for years before I got it with 1" wheel spacers and 1/2" studs. Light car and only running 6.40s-6.60s in the 1/8th.
I didn't feel comfortable with that setup so I got new wheels that didn't need the spacer. The problem to me is figuring out how much clamping force you have to have with the weight of your car, size of your tire and torque on the rearend, relating to the spacer and wheel stud involved.
Curtis
I didn't feel comfortable with that setup so I got new wheels that didn't need the spacer. The problem to me is figuring out how much clamping force you have to have with the weight of your car, size of your tire and torque on the rearend, relating to the spacer and wheel stud involved.
Curtis
Also make sure you have the longest shank (lug nut) your rim will allow.
Dave
#8
Senior Member
SENIOR BUILDER
Thread Starter
Join Date: Sep 2009
Location: Newburgh, IN
Posts: 106
I'm pretty sure the axles are factory. It's had a .373 posi installed, but I think the axles are original. Mine is more of a family fun car than anything, but I'll give her hell when I'm by myself. I'd hate to damage something (studs) and find out the hard way on a family cruise. I think I'll stay away from spacers and find some that fit. Thanx for the input.