Realigning spider gears
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Nov 2006
Posts: 2
Realigning spider gears
How do I realign the spider gears in an 8.5 in. gm 10 bolt posi. I inadvertantly rolled the differential when taking out the c clips to replace the axles and the spider gears rolled down, not out though. I had hoped when I put the new axles in I could roll it the other way and they'd go back:shock: NOT. Any positive info would be greatly appreciated.
Thanks,
Durf
Thanks,
Durf
#2
If they did not rotate all the way out, they should roll back into place. I believe this rear end has cupped washers between the spider gear and the housing. One or both of these washers may be the binding problem.
Good Luck, Dave
Good Luck, Dave