Results 1 to 5 of 5

Thread: aluminum hemi head

  1. #1
    Junior Member APPRENTICE
    Join Date
    Jan 2004
    Location
    mogadore,ohio
    Posts
    15

    aluminum hemi head

    :?: :?: broke a valve and hurt the combustion chamber on an aluminun indy cylinder head . Need s repaired. took out the valve seat completely. Any suggestions to where the repair should be taken to and approx. cost. Thanks

  2. #2
    Senior Member RACING JUNKIE
    Join Date
    Dec 2004
    Location
    austin texas
    Posts
    729
    were are you located?

  3. #3
    Senior Member RACING JUNKIE
    Join Date
    Sep 2007
    Posts
    4,143
    I'd send it back to Indy Cylinder Head.

  4. #4
    Junior Member APPRENTICE
    Join Date
    Jan 2004
    Location
    mogadore,ohio
    Posts
    15

    indy aluminum head

    Live near Akron Ohio. Was curious as to how good indy was at repairing their heads. Don't like either person---especially lazerri. Anyone have a rough estimate of how much this will cost? Thanks

  5. #5
    Member JOURNEYMAN
    Join Date
    Jun 2004
    Location
    Hamilton, OH 45013
    Posts
    32

    head repair

    try eric hinderberger at performance enginering near cincinnati. he's a TAD racer that i've known and raced with for about 25 years, until he went to tad. he repairs a lot of heads and blocks and also builds sheet metal intakes. i've seen his work and he is goooood. he also does engine work and has a wheel and engine dyno. his phone number is 513-738-5001. tell him i recomended him to you. he'll give you a good deal.. matt

  6. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy