Results 1 to 1 of 1

Thread: Caltarc Pivot Assembly Bind Problem

  1. #1
    Junior Member SHOW GUEST
    Join Date
    Jun 2006

    Caltarc Pivot Assembly Bind Problem

    I have installed a set of Caltrac's on my car with the Front Pivot Assembly secured into the spring pocket of my CE weld in Frame connectors w/ spring pockets and I have a bind and can only move they with a screw driver.

    I know that my installation is non typical based on the original design intent of the bars, but, I can't be the only one that has tried to used the bars with these CE frame connectors.

    Here is a picture of my Pivot Assembly bind, any help with this would be greatful.



  2. Racing Junk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Copyright © 2005-2016 All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy