CAM specs - your thoughts?
#1
Member
JUNIOR BUILDER
Thread Starter
Join Date: Feb 2006
Posts: 67
CAM specs - your thoughts?
Just got my engine back from the builder - went with a 496 BBC.
Converted to a roller cam/lifter set-up and he suggested a Erson custom ground cam.
Specs -
Intake: .621 lift / 306 deg duration
Exhaust: .621 lift/ 314 deg duration
108 IC
Anyone have an idea of the RPM range this cam will perform wihtin? What about streetability characteristics? Hig/ low/ no vaccum???
Sorry I am not sure what you can tell from looking at these specs but any info or feedback is appreciated.
My car is around 2900 lbs w/ driver, 3000 stall, 4.11 gears, th400 trans, 32" rear tire.
Converted to a roller cam/lifter set-up and he suggested a Erson custom ground cam.
Specs -
Intake: .621 lift / 306 deg duration
Exhaust: .621 lift/ 314 deg duration
108 IC
Anyone have an idea of the RPM range this cam will perform wihtin? What about streetability characteristics? Hig/ low/ no vaccum???
Sorry I am not sure what you can tell from looking at these specs but any info or feedback is appreciated.
My car is around 2900 lbs w/ driver, 3000 stall, 4.11 gears, th400 trans, 32" rear tire.
#6
Member
JUNIOR BUILDER
Thread Starter
Join Date: Feb 2006
Posts: 67
sorry for the delayed response - I am running RHS heads - not sure of the flow numbers but suppose to be an Eldebrock (sp?) knock off. I thought RHS was a good head manufacturer and doubt they are simply knock offs, but for what its worth that is what the builder stated.
Good to hear the cam range is exactly what I requested. Going outside to start putting the engine and trans back into the car..... fun times....
Good to hear the cam range is exactly what I requested. Going outside to start putting the engine and trans back into the car..... fun times....