Results 1 to 3 of 3

Thread: nos fogger problems

  1. #1
    Senior Member MASTER BUILDER
    Join Date
    Jan 2006
    Posts
    237

    nos fogger problems

    I have a tunnel ram that someone drilled for a nos fogger system but they had every hole stripped out. Is there any way to fix this without welding the holes up and starting over? I know BG makes a npt reducer bushing, has anyone had this problem, if so how did you fix it? The holes are 1/8 inch so I can go bigger. Thanks for any help you give.

  2. #2
    Senior Member MASTER BUILDER
    Join Date
    Nov 2007
    Location
    Wisconsin cheesehead!!
    Posts
    213
    that sucks, you can either get new thread inserts or use an adapter like they give you with universal shift knobs. both work the same basic way and shouldnt disrupt flow much more then before. be sure to seal them up tight with thread sealent glue.
    1987 Pontiac Fiero GT
    418ci SBC v8, manual 5-speed.
    dual stage nitrous injected

  3. #3
    If you can find heli-coil inserts in the proper thread they should work as long as the holes havent been made too large. once again use sealer....no teflon tape!!!


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy