Results 1 to 2 of 2

Thread: guide plates

  1. #1

    guide plates

    i just got my new pushrods but the problom is that i ordered 3/8 and my heads came with guide plates for 5/16 can i grind on these to open them up so my 3/8 pushrods go through them?or is that unsafe to do

  2. #2
    Senior Member RACING JUNKIE
    Join Date
    Mar 2003
    Location
    Fountain,MICHIGAN
    Posts
    856

    G/Plates

    My OPINION?
    Just Purchase the CORRECT G/Plates!
    You have to remember,they are riding on the Push-Rods?If the motor was only turning a few Hiundred R's?You MIGHT be OK????
    I would think 40.00 would Fix the Problem.........?
    Later
    G 8)

  3. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy