Results 1 to 3 of 3

Thread: pushrod length??sbc

  1. #1

    pushrod length??sbc

    i just made a home made screw out style pushrod to check the length of the pushrod that i may need and i came up with 8 inch.that seems to be a little to long but thats what i measured.i have a solid roller and i think solid rollers lifters are a little longer than tapped lifters.the pushrods that came out were 7.7 i was just surprised to read 8 inches with the same block i have changed to a small base circle roller cam but put in longer crower lifters and new afr 210 heads that were the same cc as the old afr heads i just want to know if 8 is a normal size for pushrods i was expecting to read somewere from 7.5-7.7 not 8

  2. #2
    Senior Member RACING JUNKIE jmarksdragster's Avatar
    Join Date
    Jul 2007
    Location
    Florida
    Posts
    635
    Mark Whitener
    http://racingfuelsystems.myfunforum.org
    __________

    Good work isn't cheap, and cheap work can't be good.

  3. #3
    Senior Member RACING JUNKIE
    Join Date
    Sep 2007
    Posts
    4,143
    Quote Originally Posted by jmarksdragster
    that's a good read.

    I set mine up that way but strange thing is the exhaust came out with the pattern dead center but the intake it is on the header side of the valve tip...but at mid lift the center of the roller tip axle and the trunion are in line so I guess it's correct. ( BBC)


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy