Results 1 to 3 of 3

Thread: ARP OIL PUMP STUD?

  1. #1
    Junior Member JOURNEYMAN
    Join Date
    Nov 2007
    Posts
    28

    ARP OIL PUMP STUD?

    On a sbc what should I torque a arp oil pump stud at?

  2. #2
    Administrator RACING JUNKIE
    Join Date
    Mar 2004
    Location
    Maine,USA
    Posts
    1,208
    There Is 1 Thing Better Than Cubic Inches,,,More Of Them

  3. #3
    Senior Member RACING JUNKIE jmarksdragster's Avatar
    Join Date
    Jul 2007
    Location
    Florida
    Posts
    635
    Check very carefully or this one will bite you, if you are using a stock block, make sure the stud does NOT extend into the bearing especially on a 400, don't ask how I found out. :cry: Aftermarket blocks should be OK.[/list]
    Mark Whitener
    http://racingfuelsystems.myfunforum.org
    __________

    Good work isn't cheap, and cheap work can't be good.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy