350 sbc ring problem???????
03-18-2008, 08:38 AM
Junior Member
JOURNEYMAN
Thread Starter
Join Date: Nov 2007
Posts: 28
350 sbc ring problem???????
I am installing a new set of rings, standard bore, only thing different is that the cylinders was honed. I have used 2 different set of rings and the oil rings are to tight to fit in the bores. piston goes right in with comp rings. I also cleaned ring grooves with no luck. Any Ideas?
03-18-2008, 10:46 AM
Senior Member
MASTER BUILDER
Join Date: Dec 2005
Location: Rutherfordton North Carolina
Posts: 192
Did you check the oil ring end gap? the rails may be butting.Bill
03-18-2008, 10:49 AM
Junior Member
JOURNEYMAN
Thread Starter
Join Date: Nov 2007
Posts: 28
ring gap
yes approx .025 oil ring gap
03-18-2008, 11:02 AM
Senior Member
MASTER BUILDER
Join Date: Apr 2006
Location: Ms.
Posts: 191
Make sure you have the correct radial thickness ring for your piston, in other words the ring could be thicker than the groove is deep.
03-18-2008, 11:13 AM
Junior Member
JOURNEYMAN
Thread Starter
Join Date: Nov 2007
Posts: 28
problem solved
in 87-88 they made a shallow groove pisto and the standard deep groove we have the shallow groove. Thanks for your input
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off