spool and bore dia. ?
#1
Senior Member
RACING JUNKIE
Thread Starter
Join Date: Sep 2007
Location: Montvale, VA
Posts: 1,431
spool and bore dia. ?
I have a 9" nodular case.It has the small 2.891" bore size.The best I can tell,33 spline is the largest axle I can buy for this center.Would like to over-build and go to 35 spline,so as to only do it once. Would I do better to find a 3.250 bore case?
#3
Senior Member
RACING JUNKIE
Join Date: Feb 2004
Location: san antonio, texas
Posts: 1,233
there are plenty of dealers just thought i would pass tom's, i
bought all the new parts to over haul my rear
www.tomsdifferentials.com
bought all the new parts to over haul my rear
www.tomsdifferentials.com
#5
Senior Member
MASTER BUILDER
Join Date: May 2003
Location: Owingsville, Ky
Posts: 157
Just a word of caution, not all brands of 35 spline axles will fit in all 35 spline spools. Some have different pitches on the splines, so it is best to purchase the axles and spool from the same vender. Also, some spools have the splines positioned farther out, which would require shorter axles. I found that on a small bearing spool for 35 spline axles for another project.
I have the Moser nodular big bearing center section, 35 spline spool, and axles in my white Monte.
Bill
I have the Moser nodular big bearing center section, 35 spline spool, and axles in my white Monte.
Bill