Results 1 to 4 of 4

Thread: rotor phaseing

  1. #1

    rotor phaseing

    i believe msd says to use a non adjustable timing gun to do this. i set my crank trigger with a adjustable gun with the knob turned to o, so wont that work also for the phasing? thanks guys

  2. #2
    Senior Member SENIOR BUILDER
    Join Date
    Feb 2005
    I use the same gun with a adjustable knob and it works fine using it to phase the distirbutor,just make sure it's on 0, Hope this helps?

  3. #3
    Join Date
    Dec 2004
    make sure you get it right for your application......
    I goofed and it cost me about 1000.00 in repairs plus down time

  4. #4
    it checked out fine and need no adjustment, thanks for your reply as i did use my gun zero'd out

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Copyright © 2005-2016 All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy