preload
#1
Junior Member
APPRENTICE
Thread Starter
Join Date: Jul 2004
Posts: 24
preload
hi help i have a chassis vega latter bar car .the guy that did have it 5f. so 120#s i weight 240 6f had to move seat back next to the tub the car truns right no matter what you do. do you thank i would need to ad weight to the right side
#2
Senior Member
MASTER BUILDER
Join Date: Oct 2004
Location: Newport News, VA
Posts: 139
Put your butt in the car and have someone adjust the preload in the right bar till the front bolt slides in and out with no resistance. Lock her down and go race. If it still turns right then add right side preload one FLAT at a time till it straightens out.
George
George
#3
Junior Member
APPRENTICE
Thread Starter
Join Date: Jul 2004
Posts: 24
done did that put all preload it dont change its like right side not even hooking at all i even check the spool the car dont just go to the right it turns soon as it moves if it was as simple as truning a bar i would be asking
#4
Senior Member
MASTER BUILDER
Join Date: Oct 2004
Location: Newport News, VA
Posts: 139
Sounds like you have something binding in there. Those ladder bars should work very free. If you have access to a set of scales I would scale the car and make a preload adjustment with it on the scales and see if it makes a difference in the corner weight. If not then you definately have something bound up or broken as in the bracket pulling away from the rear end housing or something of that nature. It doesn't take but a flat of a turn to make a noticeable change with a free and properly operating suspension.
As far as just turning the bar thing...there's no way I can tell your experience level. You don't say so I can only start at the basics.
George
As far as just turning the bar thing...there's no way I can tell your experience level. You don't say so I can only start at the basics.
George
#5
Administrator
RACING JUNKIE
Join Date: Mar 2004
Location: Maine,USA
Posts: 1,204
Originally Posted by br1984
done did that put all preload it dont change its like right side not even hooking at all i even check the spool the car dont just go to the right it turns soon as it moves if it was as simple as truning a bar i would be asking
__________________
There Is 1 Thing Better Than Cubic Inches,,,More Of Them
There Is 1 Thing Better Than Cubic Inches,,,More Of Them
#7
Senior Member
DYNO OPERATOR
Join Date: Feb 2006
Location: VA Hospital, Dallas, Tx (214 302 1924) cell-972-464-7400
Posts: 540
If one wheelie bar wheel hits down hard it will lift one tire and will rapidly steer the car to the other side. Or if bar was raidically out of pre-laod adjusting range that could also give more traction to one tire.
Ed
Ed