Machine shop in Houston area.
08-09-2007, 11:46 AM
#1
Member
CRAFTSMAN
Thread Starter
Join Date: May 2005
Posts: 59
Machine shop in Houston area.
I am building a 2 bolt 350 block and need to get splayed crank caps, and line bored. Can you recommend a Houston area machine shop to perform this job, and how much do you think it should cost?
08-09-2007, 01:21 PM
#2
Senior Member
DYNO OPERATOR
Join Date: Feb 2006
Location: VA Hospital, Dallas, Tx (214 302 1924) cell-972-464-7400
Posts: 540
Wop Shop
or
USA Racing Engines.
Same company.
I can highly recommend these guys. I have known them since 1970 and when I was in Houston and when I moved to Louisiana they did all of my machine work. I still talk with them on the phone from time to time. They have even had the same phone number since 1971.
Talk with Bruce or Earl.
713- 645 - 4000
There are also other good shops there too.
Naiser Racing Engines NRC (Jeff or Rick)
Houston Engine & Ballancing (Tommy)
Eddie Conrad Machine Shop (Eddie or Jeff)
Faerman Racing Engines (Dennis)
Ed
or
USA Racing Engines.
Same company.
I can highly recommend these guys. I have known them since 1970 and when I was in Houston and when I moved to Louisiana they did all of my machine work. I still talk with them on the phone from time to time. They have even had the same phone number since 1971.
Talk with Bruce or Earl.
713- 645 - 4000
There are also other good shops there too.
Naiser Racing Engines NRC (Jeff or Rick)
Houston Engine & Ballancing (Tommy)
Eddie Conrad Machine Shop (Eddie or Jeff)
Faerman Racing Engines (Dennis)
Ed
08-10-2007, 10:35 AM
#3
Member
CRAFTSMAN
Thread Starter
Join Date: May 2005
Posts: 59
Splayed Caps
Hey, Thanks I called the number you posted and spoke to one of the gentlemen over there and he is going to get me taken care of. He told me about 3 weeks, Do they deliver on schedule? I have heard stories of people taking months to get their motors completed from other machine shops.
