valve lash
07-29-2007, 08:39 AM
#1
Member
MASTER JOURNEYMAN
Thread Starter
Join Date: Apr 2003
Location: Fenton MI
Posts: 38
valve lash
When setting valve lash, what is the best way to spin the motor to open and close the valves? Is there something you can do other than clicking the ignition?
Thank you
Adam
Thank you
Adam
07-29-2007, 02:56 PM
#2
Senior Member
MASTER BUILDER
Join Date: Dec 2003
Posts: 185
You can pull the plugs out and turn it over with a long handle 1/2 ratchet using the damper bolt........
If you don't have one you can put a starter button on the firewall where you can reach it from eather side or just put 2 on (one on each side) and bump it over to check your lash...I think this is how most do it..Good luck
If you don't have one you can put a starter button on the firewall where you can reach it from eather side or just put 2 on (one on each side) and bump it over to check your lash...I think this is how most do it..Good luck
