ANYONE BOUGHT A MACHINED 350 BLOCK FROM COMPETITION PRODUCTS
#2
Senior Member
DYNO OPERATOR
Join Date: Feb 2006
Location: VA Hospital, Dallas, Tx (214 302 1924) cell-972-464-7400
Posts: 540
I have ot seen any of them. I do think taht an employeee named Butch Pattersonis doing all the machining. He is q pretty sharp cookie and I feel just by talkin with him on the phone , I Think that he will proabably do a good job.
Ed
Ed
#3
Senior Member
RACING JUNKIE
Join Date: Feb 2004
Location: san antonio, texas
Posts: 1,233
i have bought over a grand of parts from Competition but have not
purchased any blocks but the people are great, take care of you
and check to make sure your parts came in and that your parts
are'nt damaged, and yea the prices are great, good people. :wink:
purchased any blocks but the people are great, take care of you
and check to make sure your parts came in and that your parts
are'nt damaged, and yea the prices are great, good people. :wink:
#4
Senior Member
MASTER BUILDER
Join Date: Jul 2006
Posts: 184
Well, I have not seen any, so I can;t say for sure, but, I am pretty sure they contract with big reman shops for some of that stuff, and, I have had guys bring me stuff from shops like that, and, lets just say, its not so good. With that said, I would occasionaly buy ready to assemble Canfield heads from them, instead of bare heas, like I would normaly, when I was really busy, etc, but would still check them over. If their block work, is as sloppy and bad as the head machining they do, I would politely pass on a block from them. Thats all i will say