Results 1 to 3 of 3

Thread: 428 stroker OR 400 buildup????????????

  1. #1
    Senior Member SENIOR BUILDER
    Join Date
    Feb 2005
    Posts
    121

    428 stroker OR 400 buildup????????????

    looking for opinions on either building a 428 SBC stroker or 400 buildup,Cant make up my mind on which one to build,I using the bowtie aluminum block I have and the 6 inch rods I have,getting ready to buy the crank and pistons,just want ing to know which is gonna be my best bet for HP,this motor will be blown on alcohol!

  2. #2
    Senior Member MASTER BUILDER
    Join Date
    Dec 2005
    Location
    Rutherfordton North Carolina
    Posts
    192
    With your 6.0 rod i would use a 3.75 stroke otherwise your ring pack will need to be to far up on the piston for a blown application.Bill
    Hendrens Racing Engines
    1310 U.S. Hwy 221 North
    Rutherfordton N.C. 28139
    828-286-0780 Bill, Steve, Mike
    www.hendrensracingengines.com

  3. #3
    Member JUNIOR BUILDER
    Join Date
    Jun 2006
    Location
    The Custom Engine Shop, Indianapolis, Indiana
    Posts
    73
    Unless you are building a tall deck and then put more stroke into it.
    I am with Bill 3.75 for a std height block.
    Piston design outweighs rod length.
    CDR Performance
    The Custom Engine Shop and Sponsor of the First Annual YellowBullet.Com Nats

    If you have never experienced fear your car isn't fast enough.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy