Results 1 to 2 of 2

Thread: 4 link question

  1. #1
    Junior Member APPRENTICE
    Join Date
    Jan 2004
    Location
    mogadore,ohio
    Posts
    14

    4 link question

    I want to lower my top bars 1 hole. Problem is there isn't any holes left. My bottom bars are level.what would happen if i raised the bottom bar up 1 hole? In essence, would that have the same result as moving the top bars down? I can weld new tabs on to make the top bar lower 1 hole but was wondering if raising the bottom would do the same thing. Thanks

  2. #2
    Senior Member RACING JUNKIE curtisreed's Avatar
    Join Date
    Feb 2004
    Location
    KIEFER, OK.
    Posts
    1,309
    No, raising the bottom won't do the same thing. It will move your intersect point back and up.

    Moving the front of the top bar down moves your intersect point back and down. Check out the video below.

    https://www.youtube.com/watch?v=RABbQ9daIJM

    Curtis


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy