Intake/carb selection
OK here is my set-up. Remember this is a street/strip car(mostly street).
.030 over 350 sbc, flat top pistons (4 eyebrow), 461 heads, MSD ignition, cam I am not sure of exact size but it is approx. .540 lift with 308 dur.
I am currently running a weiand tunnel ram w/ 2 450 holley's. 4 speed trans., 4.56 gear, with 30/14.5/15 M&H cheater slicks.
My problem is that on the track the car launches hard then noses over due to lack of low end power. Slowly powers back up then runs real strong in the upper RPM's.
I am thinking of going with a single carb but not sure of which intake/carb would be best for my application. Any suggestions??