Thread: Muncie Question
View Single Post
Old 09-30-2009, 03:40 AM
  #8  
Scorpion1110
Senior Member
RACING JUNKIE
 
Join Date: Jun 2007
Location: Standing right behind you
Posts: 1,151
Default Re: Muncie

Originally Posted by fla1976
Does it go into he gears with the engine off? Sounds like a clutch issue or a shifter maladjustment.
Fla- bench tested fine; smoothest I ever built. Could row through 1-4 on the bench. Guy claims its not his clutch or shifter- but if it goes into gear smoothly, by hand and then using a wrench to flip the tabs- then that says something is mis-aligned or worn out at the linkage- plus its a comp plus in a 70 chevelle so there could be clearance issues.

The box that came out was a later 71-74 Pontiach version (2+2 tailshaft) with a 10 spline input and 32 spline out-put- an incorrect build as the input should be fine spline as well.

Supposedly the cluttch is set for the 10 spline and they are using a smaller driveshaft and fine spline yoke on the output spline.

I think linkage, clearance or clutch and TB- of course its always the builder and never the installer lol.

Scorp
Scorpion1110 is offline