View Single Post
Old 09-01-2007, 02:57 PM
  #4  
Bubstr
Member
JUNIOR BUILDER
 
Join Date: Mar 2006
Location: Illinois
Posts: 96
Default

The suburban is fairly rigid from the doors back and should be no trouble.
I would first insure that all the fasteners from the fender to cowl are tight and not able to slip. Bottom and top. Insure that the bumpers are square with body and have good gaps. Then loosen all the body mounts. There may or may not be shims at each mount, but if there are keep them straight to put back in. Then replace all the rubber mounts, install the shims where they where and align with the bumpers. The bumpers are mounted to the frame. Then tighten from rear to front going side to side. Then check the door gaps. If the doors open and close good and have good gaps you did well. If not the fender to cowl may have slipped or you mixed up shims.

Most suburbans won't have shims behind the cowl because the body is actually more rigid than the frame. That goes for full frame chevy and ford trucks.
Bubstr is offline