bjuice

Thanks Guys..the small detail work is very time consuming and aggravating work. If i cannot do it neat and my way..I WILL NOT DO IT AT ALL....

There is a lot of dust on the car that i didn't bother wiping off cause i was afraid of scratching the paint..i am getting one of those feather dusters they use at car shows.....

Any how i have a good bit more work to due to get it where i want it..

New fuel cell.
clean and flush fuel system in place ( bg 400)..(holding my breath here..i hate BG)..
Fabricate my Linakge from firewall to carbs..( having to think the best route)
figure out the best place to mount the oil tank for dry sump..i may have several options here...don't know yet..

Buy and mount tranny and run tranny lines to cooler....

Send back wheels of to champion beadlock to have the coinverted tio beadlock wheels on rear..

this doesn't sound like much..but the linkage set up may take me a week or so to figure out the geometry and right parts to make it work..

ahhh LABOR OF LOVE...

Thanks again guys.

Brian