well my motor will be done soon enough, update is as follows, we dynoed it on april 29th and it all went very smooth and motor ran well, it just didnt put out the number I wanted, and engine builder wanted, so its got a custom ground crower cam getting ground for it next week, and motor builder is going to buy a super victor intake for it, I wiil pay him for that soon, and then it will be all installed and I will go get it. I am definetly out of funds on this motor but it should run hard and be a lot of fun, here is dyno pull a few weeks ago, it made 545hp at 6600 wanted 600hp , should be right there when its all done!!!!
http://www.youtube.com/user/spib43#p/a/u/1/0JNN-hlaQw8
http://www.youtube.com/user/spib43#p/a/u/0/GIJad9FTAaU