View Single Post
Old 12-01-2018, 05:36 PM
Senior Member
mytmouz's Avatar
Join Date: May 2006
Location: Pelahatchie, MS
Posts: 1,006

Health issues (for me, and a couple of family members) have prevented me from getting back to this until today. I had a carb issue, as noted a few pages back, when I got it running, and swapped to a different carb, but it had a blown power valve, so it was always hard to start, and ran, but not crisply. Swapped over to another supposedly "good" carb, that I got in trade, and promptly had to rebuild it (I hate ethanol fuel). Still popping occasionally through the carb at idle, and poor throttle response. Tore down the carb that has been on it, all looked good, except for the blown power valve, and replaced it. Same issue. The intake was sucking air along the gaskets. Retorqued them, and Sweet times are here. Absolutely no traction through the first 3 gears now...

I still have to finish up the gauges, and finish the side pipes. Then buy some drag radials I guess, even though this is a driver...
mytmouz is offline