View Single Post
Old 12-06-2017, 05:37 AM
Junior Member
Join Date: Dec 2017
Posts: 1
Default Motor Plate / Mid-Plate Install

Hello all, I am currently building a big-block equipped, street/strip 70 Chevelle from the ground up. I expect low 10 second quarter mile times. It will race on 10-1/2" street slicks and have a fully adjustable, factory style 4 link rear suspension from Dick Miller Racing. It will be built on it's original chassis plus some modifications and a roll cage later in the build. At this time, I am trying to configure a front motor plate and mid-plate (with engine limiter). I don't want to move the engine forward or back at all, but I suspect there is an opportunity here to improve the original engine mounting angle.
Does anyone have any input before I weld the engine into the exact location that GM used?
Vinamite is offline