prostreet1972

I have a 72 chevelle back halved ladder bar setup, 6 point cage. I was running all solid motor and trans mount. My trans case broke towards the back right by the round thing that a bench mount transmission stand screws into on the left side up ove the top and then back to where the vaccum modulater mounts.

it is just a mild 350sbc, TH350 with shift kit, 5.14 gear footbrake car. Runs low 8.2s in the 1/8 and ran 7.72 on 100hp shot of nitrous

I now know that I shouldn't run all 3 solid mounts, I have installed a poly mount now. Just curious what else would have caused this and what else should I check to hopefully not happen again?

I hope to be getting a 10 point cage here soon, maybe even a 12 point.

Any help is greatly appreciated.

Thanks,

Travis