i agree with Johnracer....you can plate that frame front to back..but i personally do not think this is gonna give you the strength you are looking for ( in the right places so to speak) if it were mine and i wanted to beef up suspension i would concentrate on eliminating as much chassis flex as possible #1- is the cage. ( if not then the rest i am about to mention would be a must)
...front motor plate ( conventional or makeshift) same with mid plate,engine torque limiter...i would diamond plate the seams on the front clip.( see pic attached).. ...southside suspension,caltracs....
even a low compression 632ci ( if well built) is gonna be enough to put down some serious numbers.
just giving you some of opinions of what i would do if i were going your route..
hope this helps.
Brian
[img]
[/img]