lmccoll

We have a 10 Bolt rearend in a 74 Camaro, this is a drag car only. I bought a set of Moser axles with C clip eliminators.

In the installation instructions, it said to cut off the rearend housing where the eliminators bolt on to 1/4" and I have done that. The problem is, it seems the new axles with the eliminator/bearing don't quite fit all the way up to the bolt holes on the brake flange. I think it is suppose to fit flush.

After doing some measuring, the problem appears that the rearend housing is cut correctly, but inside the rearend housing end, where the old wheel bearings and seals were is the problem.

Where the old wheel bearings were, there is a slight lip, I filed off a little of this lip and the axle did go in a little further, but I am afraid to remove to much of this material since this is the axle housing. Anyone else have this problem?

Thanks for any help.