Thread: piston ring gap
View Single Post
Old 12-07-2007, 10:05 AM
  #4  
fishman1
Senior Member
MASTER BUILDER
 
Join Date: Dec 2005
Location: alberta,canada
Posts: 166
Default

Originally Posted by gimmemud
Whatever the manufactuer recomends, there should be directions with them, should be determined by bore size.

When all else fails, read instructions.
Sorry but the reason i am asking is because i do not have instructions and i cannot find any info form the manufacture on there web site.


I am not using nos and the block is iron and the block is not filled......strictly drag application.........thanks
fishman1 is offline