Originally Posted by cepx111
Originally Posted by markdunlap
. If the needle and seats are misadjusted too high or get stuck, the fuel will usually all come out the sight plug holes without going up and over the vent tubes and into the carb and engine. If there are no sight level plugs, put hose over the vent tubes and route away from the carb to a catch can.
Thats a pretty good idea right there ^
Cp
Hell that takes all the fun outta turning the pump on, running around to watch and see if it's ok or spilling into the motor then running back to shut the pump off, then having to drain the oil because you filled the motor full of fuel!! Been there done that several times!
ops:
Sometimes it's just easier to sit back and think for 2 minutes about what you're doing before you start.
Good simple idea.