View Single Post
Old 11-26-2011, 03:52 AM
  #8  
TRChassis
Junior Member
JOURNEYMAN
 
Join Date: Oct 2007
Location: Las Cruces, NM
Posts: 29
Default

Well we have tried just about everything, except transbraking it to 5,000. We usually use about 3-4000 rpm. We have tried changing the low end tune up, different tires and tire pressures. The tracks in this area are not the best, but they do prep them pretty good. I guess what I was getting at is that if there is a possibility the convertor is just locking up from the launch, in other words should I send it back and have it set up for a "softer launch" (if there is such a thing). We used to run lencos and could adjust the clutch a little for the shake but I am lost with this convertor/tire shake.

Rick
TRChassis is offline