454 blower motor trouble
?? on BBC 454 stroker blower build up.
1. 1991 Truck block.
2. K-Motion did the machine work on short block.
3. My Father installed Summit heads and 6-71 blower.
problem is that the motor "appears to be sucking oil out of the valley into the driver side intake and blowing out of the driver side exhaust" like I said "appears" to be.
1. We disassembles and inspected the motor everything looks good except cam (wiped it out).
a. noticed that the intake gaskets were not "crushed" or marked except for a small section along the top edge on both sides.
b. the bottom of the gasket appears to be untouched.
When the block was decked, could that have changed the angle were the intake mates with the engine enough to cause it to suck oil?
I measured the angle between the deck and the heads and got about 135 degrees.
I measured the angle of the intake and got about 134 degrees.
(i say about because i really don't have an acurate protractor)
ANY ideas???
Thanks ( I am new at this so be gentle with me )