Thread
:
Rear disc brake drag
View Single Post
04-28-2009, 06:47 PM
#
4
TheYellaBrick
Senior Member
RACING JUNKIE
Join Date: Mar 2008
Location: Emmett, Idaho
Posts: 7,334
The puck is not retracting as it should, thus dragging the pads and heating up the whole assembly. Disassemble, hone, and replace the puck ring. Pull the caliper, place a piece of 1 X 4 in between the puck/s and gently apply air pressure into the brake line fitting. POP ! and the puck/s are out ! Make sure you have no little appendages in there !! I got rudely awakened one time *@#%&*** :roll:
ops:
ops:
ops:
ops: :x :cry: :cry: :cry:
Reply
TheYellaBrick
View Public Profile
Send a private message to TheYellaBrick
Visit TheYellaBrick's homepage!
Find More Posts by TheYellaBrick