View Single Post
Old 09-05-2007, 07:55 PM
  #1  
hellisht
Junior Member
SHOW GUEST
 
Join Date: Jul 2006
Posts: 3
Default rear suspention question

first off i have back halfed a 62 nova, custom sub conectors and an alston front clip. i did all the work related to this off my some what flat garage floor. after leveling 100 times and checking the mesurements 100 times befor welding the rear end does not seem to be centered, or aligined perfectly with the cross member.4 link car. if there is nothing stock to mesure off how does one know if the rear is square in the car. aviosly if my work was perfect i could mesure side to side off the frame rails and front to back off the cross member. i centered the side to side off the fenders and front to back off plum bobs i hung from the fenders, centering the wheel in the wheel well. is this close enough, and will an allighnment shop make it correct so the car will track correct with the front end. hope this is not super stupid. any help would be great.
hellisht is offline