View Single Post
Old 09-02-2018, 06:29 PM
  #12  
mytmouz
Senior Member
RACING JUNKIE
 
mytmouz's Avatar
 
Join Date: May 2006
Location: Pelahatchie, MS
Posts: 1,009
Default

And while it doesn't look like much, it took all day to do it...

Cut a piece of anodized diamond plate to fit, mounted the through bolts with countersunk screws to hold the bed sides at the bottom, then mounted the access doors for the battery and fuel fill. Then masked off and bedlined the bed sides, tail gate, and front bed panel. Then installed the stainless bolts for the bed side fenders. Also, not shown, but the new chains for the tail gate are on as well...

mytmouz is offline