Well as you guys already probably know I did not get my carb swap completed in time.
I am just now ready to install.
Here is what happened.
Got my new Demon, noticed the inlet sizes are different than the Holley's.
Tried to find a fuel log locally, no one had one.
Ordered it overnite from Jegs.
Jegs delayed order and didn't get it until yesterday evening.
Went to put it on and the lip at the end was hitting at the bowl screw....this from jegs and their statement that it fit ALL standard Demon carbs.
Found the right size adapters and the front inlet was buggered up and stripped.
Had to find a 9/16x24tpi tap.
Just got it and just got inlet installed....no way I can make it to Yakima and race.....I am so very upset but will not go into that :cry: :cry: :twisted: :twisted: :x :x