Hooking up shifter solenoid to 7al3
I have a two wire solenoid,one white and one black,when I hooked it up to the box ,the white one to battery power,and the black wire to the RAS output side of the box,with a 12 volt jumper wire from the ignition to the RAS input side.and when i tested it,It did not seem to have enough voltage to fully engauge the solenoid,I also noticed that when I put a test light on the ground side of the RAS output,my test light was getting some power to light up,could this be a feedback problem with the 7al3 box,or could it be the solenoid.I connected this according to the MSD instructions,all connction are tight,and battery was fully charged.any help would be greatly appreciated,Thank you Scott.