This isnt No powerglide!
Hello
I was cleaning up what was thought to be a aluminum power glide case, to use in a dragster project... I noticed it look just like a power glide on the outside, I dug out the Powerglide handbook just to see what year it was, noticed the numbers were not listed. What I found was the case is weird in the back behind the governer support. The hole you inlarge for a transbrake isnt there, Its either next to the horse shoe, in later models or up top left hand on early models. There also is No hole inside the horse shoe. The cavity next to it is large with no divider. There is a small hole maybe 1/8 inch inside were the hole should run back through the governer support, but only does down to the feed area under the pan?? Were it normally says Power glide on passenger side of tranny, it says nothing, the pad is cast but not stamped. All other ribs, vents, tranny line etc look to be in the normal spot
Can This case be used?
What is this thing?
I havent much experiance with GM transmissions..But I dont think its a turbo of some sort.