Thread: CNCRacingHeads
View Single Post
Old 05-19-2009, 08:57 PM
  #9  
michael1
Senior Member
MASTER BUILDER
 
Join Date: Jan 2006
Posts: 237
Default

Originally Posted by topsportsman1
http://www.racingjunk.com/post/1369519/DART-BIG-CHIEF-HEADS-CNC-PORTING-520-CFM.html

I've never heard of this outfit,but thats not sayin they aren't a legit company either.

I got a question,if you was going to use RFD why are you not using RFD (Curtis) now? I am sure Curtis has alot of experiance with these heads you got.

Also why not support the people that support us here at RJ? Curtis is here in the forum ,in the engine section,and we all know he is for real,why go else where?
I am sure he has done work here for quite a few folks,and have never heard a bad word about Curtis,(RFD)
Ok Tom, It looks like the guy at www.cncrh.com also known as (TK Racing) did a number on my heads. :cry: :cry: I spoke with Curtis and as soon as I get this straightened up I will be getting a set done by him. I should have used Curtis in the first place. Please don't bash me, it was a very expensive lesson learned.
michael1 is offline